Cut 1x8 into 3 30' pieces. Join the boards along the edges by drilling pocket holes in the sides of the center board about 5-6' aside. Make certain the pocket hole on the highest of the boards is low sufficient that it's going to not be cut by way of whenever you add the decorative prime.

Use a Kreg Shelf Pin Jig to drill holes for the adjustable shelves within the sides. Cut the sides and prime for the carcass or field of the cabinet. I used hardware material as a substitute because I had some readily available from another project. Using rooster wire instead of hardware fabric would give this project an even more rustic look. You may also make a raised panel door or glass panel door instead.

The quickest and best way to return your order is at any of our convenient store places. For more data, visit our Returns info web page. While the Store Associate is making ready your order, please prepare your vehicle for the order to be loaded.

If you've a router you could add a cove or ogee element to the highest and backside. You may also add a round over element to the entrance fringe of the shelves. I sanded the wooden clean and utilized the paint with this paintbrush.

Apply wood glue to the sides of the boards, clap them together and secure with 1 1/4' pocket hole screws. When the shellac was dry I lightly sanded the cabinets with 220 grit sandpaper. I eliminated the sanding dust with a ShopVac and applied three coats of this matte-end Minwax Polycrylic. I sanded with 220 grit sandpaper between each coat and removed the sanding dust with a ShopVac. After the third coat of stain was dry I lightly sanded the shelves with 220 grit sandpaper.

And it doesn’t get any simpler than this Bluetooth enabled label maker . Keep all your knives simply saved away with this in-drawer knife dock, which uses skinny cork pieces to separate the blades – and help them stay sharp. We come to you as a design consultant providing a free estimate.

I eliminated the sanding dust with a ShopVac and utilized one coat of wax-free shellac with a cheap chip brush. I utilized three coats of this coffee stain with a rag and allowed the cabinets to dry two hours between each coat. I painted the cabinet with two coats of this chalk-kind paint. When the glue is dry, minimize 2 pieces for the top and bottom. Apply glue to 1 fringe of the cleat, place inside the cupboard and clamp.

Chalk-sort paint dries shortly so I was able to apply two coats in just some hours. This is a straightforward do it your self project for DIYers of any skill level. It’s made with only a few basic tools which makes this a fantastic project for beginners.