short-term stringer from the primary unit to the second, making sure the requirements are perfectly parallel. The pins that safe the standards to the ground are nothing more than 1/four-in. lag screws with their heads cut off with a hacksaw. Install a pair of 3-in lag screws within the backside of every normal.

All the necessary hardware along with very clear directions had been included. Basically, set up the rolling ladder hardware to the face of the cupboard in accordance with the producer's instructions. The ladder is a security hazard for babies, so adult supervision is advised.

To hold your bit from wandering as you drill, use a middle punch to dent the metal at your mark. Availability is predicated on location, please select a store to view stock.

Also, make sure to nail the aspect trim even with the fronts of the standards. Since the plinths are wider than the fluted casing, you may need to tear 1/four in. holes for the second standard into the ground and set it in place. File the ends of the steel pins in order that they slide easily into the holes in the ground.

Use a wrench to show them till the threads are all inside the bottoms of the 2x4s. Turn the lag screws into the holes with an finish wrench, leaving half of in. Next, cut the heads off the screws with a hacksaw and file a slight taper on the bottom of the protruding screw shaft close to the end to assist information the pins into the holes you will be drilling later into the ground. These pins will hold the requirements into holes within the floor . long piece of delicate steel out of your ironmongery store.